Description
- S-Series Storage Sections must be stabilized with either Crossbraces or Back Panels
- Crossbraces (or Back Panels) are required on end sections of each run and every fourth section in between for stabilization
- See diagram below for minimum recommended placement of Crossbraces per run
- Back-to-back runs can share Crossbraces if Uprites are securely connected with S-Series Storage Screws (#SS2221)
- If section height is over 96″, the part number below includes two sets of Crossbraces for the section (one lower and one upper Crossbrace)
MINIMUM BRACING REQUIREMENTS DIAGRAM
Section Width: 3′, 4′
Section Height: 36″, 48″, 60″, 72″, 84″, 96″, 108″, 120″, 144″
Bracing Type: R, H
Standard Finish: GLV
